Texas Instruments MSP430 - Manual (Page 93)

Jumper JP3
1-2 (int): Power supply via JTAG debug interface
2-3 (ext): External power supply
Connector J5
External power connector
Jumper JP3 to ‘ext’
USB Connector
BSL invoke button S3
Jumper JP4
Close for USB bus powered
device
Jumper JP2
Open to disconnect LED
LED connected to P1.0
Jumper JP1
Open to measure current
Jumper JP5 to JP10
Close 1-2 to debug in Spy-Bi-
Wire mode.
Close 2-3 to debug in 4-wire
JTAG mode.
www.ti.com MSP-TS430PN80USB
Figure B-40. MSP-TS430PN80USB Target Socket Module, PCB
93 SLAU278F – May 2009 – Revised December 2010 Hardware
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated