Texas Instruments MSP430 - Manual (Page 42)

MSP-TS430L092 Active Cable www.ti.com
Table B-4. MSP-TS430L092 Active Cable Bill of Materials
No. Per
Pos. Ref Des Description DigiKey Part No. Comment
Board
C1, C3, C5,
1 4 100nF, SMD0603
C6
2 C2, C4 2 1uF, SMD0805
3 R1, R10 2 10K, SMD0603
4 R2 1 4K7, SMD0603
R5, R6, R7,
5 4 100, SMD0603
R9
6 R8 1 680k, SMD0603
7 R11, R15 2 1K, SMD0603
8 R12 0 SMD0603 DNP
9 R13 0 SMD0603 DNP
10 R14 1 0, SMD0603
11 IC1 1 SN74AUC1G04DBVR Manu: TI
12 IC2, IC3, IC4 3 SN74AUC2G125DCTR Manu: TI
Reichelt:
13 J2 1 MICRO_STECKV_10 MicroMaTch-Connector: MM
FL 10G
Put jumper on Position 1 and
14 JP1 1 2x2 Header JP2Q
2. Do not mix direction.
15 JP2 1 2-pin header, male, TH SAM1035-02-ND place jumper on header
16 JTAG 1 14-pin connector, male, TH HRP14H-ND
BC817-25LT1SMD, Digi-Key:
17 Q1 1
SOT23-BEC BC817-25LT1GOSCT-ND
18 U1, U2 2 TLVH431IDBVR SOT23-5 Manu: TI
42 Hardware SLAU278F – May 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated