Initial dvr set up procedure – Toshiba Tevion TSD-DR40HD User Manual
Page 10
Computer System HyperTools
Tevion TSD-DR40HD User Guide
F:\Our Files\Our Computers\User Guides\Tevion (Wintal)\Tevion TSD-DR40HD DVR User Guide.doc
18/9/08 at 21:49
Page 7
3. Initial DVR Set Up Procedure
After all device connections have been accomplished a number of initial setup procedures will
need to be performed. Areas shaded in grey may or may not be needed as part of the procedure
(they are mostly to do with our particular procedures for powering devices up or down).
3.1 Searching for Australian Free-to-Air TV Channels
Since we are (in Australia) still using analogue TV signals, the available channels need to be
configured:
1.
On
TRC
press
Power
button to turn on the TV (if not already on).
2.
On
TRC
press
button until
2
is shown.
3.
On
DRC
press STANDBY/ON button to turn on the DVR and wait until “No disc”
message is shown.
4.
On
DRC
press SETUP button to enter “Setup” menus and display the “Setup Menu –
Recording”.
5.
On
DRC
press Right Arrow button to actually enter “Setup Menu – Recording”.
6.
On
DRC
press Down Arrow button to “Auto Scan Channel” option and press SELECT
button.
7.
On
DRC
if prompted to confirm the action just press SELECT button.
8.
On
DRC
in “Scan Channels” screen press SELECT button leaving “Tuner input source”
set to “Air”.
9.
On
DRC
press SELECT button to start a search for Analogue TV Channels.
10. The actual scanning will take a minute or two and will probably find six Fre-to-Air TV
channels. Each channel found is identified by a program number (Pxxx) and a channel
number (CHzzz).
11. On
DRC
press Down Arrow button to “Program Table”. Then press SELECT button to
enter the “Sort” screen where the list of program numbers and channel names will be
visible. The list is as follows:
P003
CH002 (should be renamed ABC01)
P009 CH007
P011 CH009
P013 CH010
P025
CH028 (should be renamed SBS28)
P028 CH031
12. On
DRC
press Down Arrow button to get to P003 CH002 then press the SELECT
button to enter the “Modify channel information” screen.
13. On
DRC
press Down Arrow button to move down to the Name field and change it one
character at a time to the desired name (e.g. CH002 changed to ABC01) and leaving all
other settings as they are.
14. Repeat Steps 11-13 renaming CH028 to SBS28.
15. On
DRC
press SETUP button to exit “Setup” menus.