End user license agreements (eulas), End user license agreements 169 – Toshiba Portege G810 User Manual
Page 170
End User License Agreements
169
End User License Agreements (EULAs)
profits, special, indirect or incidental
damages.
This limitation applies to:
• anything related to the software, services,
content (including code) on third party
internet sites, or third party programs, and
• claims for breach of contract, breach of
warranty, guarantee or condition, strict
liability, negligence, or other tort to the
extent permitted by applicable law.
It also applies even if Microsoft should have
been aware of the possibility of the
damages. The above limitation may not
apply to you because your country may not
allow the exclusion or limitation of
incidental, consequential or other
damages.
17.EXPORT RESTRICTIONS. The software is
subject to United States export laws and
regulations. You must comply with all domestic
and international export laws and regulations
that apply to the software. These laws include
restrictions on destinations, end users and end
use. For additional information, see
www.microsoft.com/exporting.
End User License Agreement for
ArcSoft Software
The following is a legal software license agreement
between you, the software end user, and ArcSoft,
Inc. Carefully read this license agreement before
using the relevant ArcSoft software ("Software").
Installing the Software on a computer or other
hardware device indicates that you have read this
license agreement and agree to its terms.
1. Grant of License. This license permits you to
use one copy of the Software included in this
package or product on any single computer. For
each software licensee, the program can be "in
use" on only one computer or hardware device at
any given time. The Software is "in use" when it
is either loaded into RAM or installed into the
hard disk or other permanent memory of a
computer or other hardware device. A special
license permit from ArcSoft is required if the
program is going to be installed on a network
server for the sole purpose of distribution to other
computers. You may not modify, translate,
reverse assemble, decompile, disassemble or
otherwise attempt (i) to defeat, avoid, bypass,
remove, deactivate or otherwise circumvent any
software protection mechanisms in the Software,