Toshiba MA-1595-1 - Manual (Page 205)

6. PROGRAMMING OPERATIONS EO1-11152
6.23 Foreign Currency Exchange Rate Setting
6-52
6.23 Foreign Currency Exchange Rate Setting
In this program, the rate of each foreign currencies (corresponding to the [CUR1] to [CUR5] keys) will be set. By
setting a rate on each Foreign Currency Key, reading the sale total and tendering in the foreign currency value
will be possible for sale finalization.
Anytime outside a sale
Mode
Lock: SET
| Exchange Rate for Foreign Currency 1 | [CUR 1]
| Exchange Rate for Foreign Currency 5 | [CUR 5]
As for how to calculate the Exchange Rate, see the description below.
Foreign Currency Exchange Rate Calculation
1. The rate must be calculated in the subsidiary currency unit values for both the domestic and the foreign
currencies. (In case of calculating the rate from the domestic to a foreign currency with the same zero-
suppress form, such as from U.S. $ to Euro, it will be no problem even if it is calculated in the main currency
of $ and Euro. However, in case of exchanging from a domestic currency such as $ or Euro to Japanese
yen, or vice versa, this rule must be obeyed; otherwise a wrong rate will result.)
2. Calculate the required foreign currency value equivalent to the domestic currency value “1”. Then the
obtained value is the Exchange Rate value to be entered in the setting operation stated above.
3.
The result of calculation is rounded up.
Example)
To set two foreign currency rates:
(The rates here are merely examples, and may be different from the actual rates currently in effect.)
Conditions given for Domestic Currency and Foreign Currencies
(DOMESTIC) (CUR 1) (CUR 2)
U.S. Dollar EURO Japanese Yen
$1.00
€
1.0914 ¥117.10
1 cent 1.0914 1.1719 yen
EURO Cent
0.000001 to 9999.999999
(Use the [.] key if decimal portion is contained in the rate.)
OPERATION
CONDITION