Toshiba MA-1595-1 - Manual (Page 170)

6. PROGRAMMING OPERATIONS EO1-11152
6.6 PLU Table Programming (Submode 4)
6-17
DEPARTMENT TABLE PROGRAMMING CONTENTS (continued)
Address No. Description of Programming Contents
(5) 3. When the Age Limit 1 or Age Limit 2 Status is set to ON, the age confirmation is
always necessary before entering a sales item. Neither Code 6 (Age Limit 2
Status) nor Code 7 (Age Limit 1 Status) can be combined with Codes 5 and 8
on the Status Code 1 selection (Scale Allowed).
4. On the application, the Age Limit 1 Status is applied to a sales item with the
age limit younger than that of the Age Limit 2 Status.
5. Code 3 item (Tare 3 Entry or Net to Selective Itemizer 4) is subject to the status
of Address 7, Bit 5 of the system option.
This code and Code 8 on the Status Code 1 selection (Gift Card Department)
cannot be set simultaneously for a department.
6 Tax Status
• Enter a one- to four-digit Status Code for applicable Taxes. Or enter 0 if the department
handles non-taxable items.
[#]
0: Non-taxable
1: Tax 1 (Tax 1 taxable)
2: Tax 2 (Tax 2 taxable)
3: Tax 3 (Tax 3 taxable)
4: Tax 4 (Tax 4 taxable)
NOTES: 1. The rate of each Tax will be later be set and described in Section 6.24 Tax
Table Setting.
2. In case of inclusive tax, the combination of the tax status is unavailable. Only
one inclusive tax status can be programmed for a department. (Tax 3 taxable or
Tax 4 taxable)
7 High Amount Limit
Enter a maximum of 7 digits to be set as the high amount to be locked out.
Example) To prohibit any amount equal to or larger than 40.00:
4000
[#]
(Allows any amount equal to or smaller than 39.99.)
NOTES: 1. To cancel the preset limit (i.e. to allow any amount), enter 0.
2. The limit amount set here will be applied to entries in REG mode only, but not in
MGR or - mode.
3. Zeros must be entered as all the digits other than the highest digit. If any other
value is entered, it will be regarded as a zero.
ex.) Entering 4001 to 4999 will all result in setting 4000.
8 Low Amount Limit
Enter a maximum of 7 digits to be set as the low amount limit.
Example) To prohibit any amount less than 4.00:
400
[#]
(Prohibits any amount less than 4.00.)
NOTES: 1. To cancel the preset limit (i.e. to allow any amount), enter 0.
2. The limit amount set here will be applied to entries in REG mode only, but not in
MGR or - mode.
3. Zeros must be entered as all the digits other than the highest digit. If any other
value is entered, it will be regarded as a zero.
ex.) Entering 401 to 499 will all result in setting 400.
(More than one code can be entered for
combining Tax1 to Tax4 taxable status.
For example, enter 12 to select Tax1 and Tax2
taxable status.)