Toshiba DK 24 - Manual (Page 33)

Chapter 4
LCD Alphanumeric messages, names, memos
The LCD on your telephone can be used to send or receive messages to
or from other LCD telephone users. The LCD can also display the
names/numbers of the person calling your telephone or the name of the
person you are calling. Names and memos can also be set to display
with speed dial numbers and timed reminders.
STORING A MESSAGE IN MEMORY
The LCD Msg Select LED flashes.
Personal message (10 ~ 19); system message (60 ~ 99 port 00 only).
The current message, if any, will be displayed.
The LCD Msg Select LED lights steadily, and the LCD displays the
message. The message will now be stored in system memory.
The LCD Msg Select LED goes out, and the message will no longer
appear on the LCD, but it will remain in memory.
RECORDING A MESSAGE
recording a message, name, or memo
Use this procedure to enter the characters of a personal message (10 ~
19) or system message (60 ~ 99, Station 200 only), to add to a
preprogrammed message, or to edit and set a new message. After
calling up a message on your display (see Storing a Message in Memory,
Steps 1 and 2 above), perform one of the following procedures:
Figure 4–1
STRATA DK MESSAGES AND MEMOS
4-1
To Store a Message in Memory:
1. Press the LCD Msg Select
(or Intercom 6 8 ) button.
2. Dial the 2-digit message
number to be stored.
3. Use the Recording a
Message procedure to enter
the message characters.
4. Press the LCD Msg Select
(or Spkr ) button.
5. Press the LCD Msg Select
(or Intercom 6 8 Spkr )
button.
M S G N O . ?