Tascam DR-07 - Manual (Page 53)

TASCAM DR-07 53
The following procedures explain how to use the
Record Screen to set the levels.
1 Press the
RECORD key to begin recording
standby. The key flashes red and the Record
Screen appears. The input signal is output
from the /
LINE OUT jack.
2 Use the REC LEVEL volume control on the
right side of the unit to adjust the input
level.
The L/R meter shows the input level. If the input is
too high, a line remains at the right end of the level
meter and the
PEAK indicator to the left of the
RECORD key lights.
Set the level as high as possible without causing
the
PEAK indicator to light when the loudest
sounds occur.
• When you have selected
MIC
as the input source
and are using the built-in microphone or MIC IN
jack, if you find the level to be too low even when
the
REC LEVEL volume is at maximum, use the
MIC Input Setting Screen to set the
GAIN
item to
8–Recording