Tascam DR-07 - Manual (Page 51)

TASCAM DR-07 51
8–Recording
other items affect both the built-in microphone and
MIC IN .
GAIN
Set the input sensitivity as
HIGH
,
MID
, or
LOW
.
The factory default setting is
MID
. Change it to
HIGH
if the input level is too low.
TYPE
Select
STEREO
or
MONO
according to the type
of connected microphone. The factory setting is
STEREO
. If you select
MONO
, a mixed signal of
the left and right input signals is provided to the
left and right channels respectively.
POWER
When connecting an external microphone that
requires plug-in power set this to
ON
. The factory
default is
OFF
.
CAUTION
Set this to
OFF
when using the built-in mic or
connecting a dynamic microphone or micro-
phone with a built-in battery. If set to
ON
, the
plug-in power may damage such microphones.
LOW CUT
The factory default setting of the low cut filter is
OFF
, but you can also select
40HZ
,
80Hz
or
120Hz
as the cut-off frequency for a low cut filter.
TIP
Try using one of the low cut filter settings when
recording outdoors or another place where the
unwanted sound of wind is being recorded.
LEVEL CTRL
Use this to set the level control function.
Set it to
AUTO
to have the DR-07 automatically
adjust the input gain according to the input level.
Loud sounds and quiet sounds are both adjusted
to the same level.
Set it to
LMT
to have the DR-07 automatically
limit the input gain so that input level of loud
sounds are reduced to prevent distortion.
The factory default setting is
OFF
.