Tyan Computer TEMPEST S5375 - Manual (Page 53)

53
3.2.10 Remote Access Configuration Sub-Menu
You can use this screen to view the Remote Access Configuration Menu. This
feature allows access to the Server remotely via serial port. Use the up and down
arrow (З/И) keys to select an item. Use the Plus and Minus (+/-) keys to change
the value of the selected option. The settings are described on the following pages.
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Configure Remote Access type and parameters
Remote Access
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Sredir Memory Display Delay
[Disabled]
[COM1]
[3F8h, 4]
[115200 8, n, 1]
[None]
[Always]
[ANSI]
[Enabled]
[No Delay]
Select remote access
type.
←
→ Select Screen
↑↓ Select Item
+/- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
Configure Remote Access type and parameters
Enabled
Remote Access
Disabled
Enables remote access to system
through serial port.
COM1
Serial Port Number
COM2
Select Serial Port for console
redirection. Make sure the
selected port is enabled.
Base Address, IRQ Read only
115200 8,n,1
57600 8,n,1
38400 8,n,1
19200 8,n,1
Serial Port Mode
9600 8,n,1
Select Serial Port settings.