TRENDnet TEG-S081FMI - Manual (Page 74)

Max Age
You can change Max Age value, The number of seconds a bridge waits
without receiving Spanning-Tree Protocol configuration messages before
attempting a reconfiguration. Enter a number 6 through 40.
Hello
Time
You can change Hello time value, the number of seconds between the
transmission of Spanning-Tree Protocol configuration messages. Enter a
number 1 through 10.
Forward
Delay
time
You can change forward delay time, The number of seconds a port waits
before changing from its Spanning-Tree Protocol learning and listening
states to the forwarding state. Enter a number 4 through 30.
3. The following parameter can be configured on each port , click set
Apply button to modify .
Paramet
er
Description
Port
Priority
You can make it more or less likely to become the root port, the rage is
0-255,default setting is 128
the lowest number has the highest priority. If you change the value,
you must reboot the switch.
Path
Cost
Specifies the path cost of the port that switch uses to determine which
port are the forwarding ports
the lowest number is forwarding ports, the rage is 1-65535 and
default value base on IEEE802.1D
10Mb/s = 50-600 100Mb/s = 10-60
If you change the value, you must reboot the switch.
74