Tripp Lite UPS SNMPWEBCARD - Manual (Page 15)

Troubleshooting
Adding an Email Contact—To configure an email address to use when events occur, click on the New button and fill in the
information in the pop-up window. Once the SMTP server and at least one email contact have been added, you can send a test
email to verify that the settings are correct. To send a test email, click on an email contact and then click the Send Test Email
button. Note: In order for Events to send an email it is necessary to turn on email notification for each event in the Settings-Event
menu.
Figure 4-7: Contact Settings Menu
SNMP—The SNMP tab allows for configuration of SNMP Trap destinations. To configure SNMP traps it is necessary to define
the IP address and the community name to use when traps are sent out. Click on the New button and fill in the information in the
pop-up window. In order for Events to send a SNMP trap, it is necessary to turn on SNMP trap notification for each event in the
Settings-Event menu. (See Figure 4-8.)
13