Binatone FS-404 D - Manual (Page 7)

7
ENGLISH
time resetting mode; to do this, simultaneously press the buttons
«0/I» and «PROG».
11.For quick start, press «0/I» twice. The operation indicator (18)
will light up, an audio signal will sound and the food steamer will
start cooking. The preset time (40 minutes) will appear in the dis-
play (20), and the appliance will start the countdown.
12.If you want to set up another operation time for the food steamer,
press the «0/I» button. The preset time (40 minutes) will appear in
the display (20). While the time digits are blinking, decrease or
increase it, by using the «+/-» buttons, respectively. Confirm the
setting by pressing the «0/I» button.
13.To cancel a time setting, press «0/I» while cooking. The display
(20) will stop the countdown of cooking time and will return to the
clock mode.
14.Time can be increased or reset while cooking. To do this, press the
«+/-» button the required number of times. Once the set up time
indicators stop blinking, the appliance will start operating in ac-
cordance with the new settings.
15.If the water level approaches the lowest mark, add water in the
reservoir (14) through the water inlet (21).
16.When foods in the upper basket (3) are ready, carefully remove
that basket from the food steamer and cover the remaining
basket(s) with the lid.
Attention : Do not forget that steam can escape from the
appliance during cooking. Be careful and always use oven
gloves to remove the baskets from the food steamer. Always
cover the upper basket with the lid.
17.Upon the expiration of the cooking time the food steamer will turn
off automatically. You will hear an audible warning signal and the
indicator lamp (18) will go out.
Note : While cooking big dishes (chicken, for instance), you
can remove the bottom of the steam basket (8) to increase
the useful capacity of the food steamer (ref. to Fig. B). For
this purpose, push the bottom of the steam container from
below with your left hand and hold the removable bottom
from inside with your right hand, simultaneously releasing
the rim (9) from one of the clamps of the steam container
(7)
. Release the rim (9) from the remaining three clamps (7)
by pushing it with the right hand thumb (Fig. B). To reinstall
the container bottom, place the rim (9) in the steam con-
tainer (7) clamp from one side. Follow the same procedure
and fix the bottom (8) in the three remaining clamps (7) by
pushing the container bottom toward the center to allow the
clamp (7) to sit under the rim of the steam container (9).