SENAO EnGenius EP-801 - Manual (Page 22)

~43~
looking for.
7. To erase phonebook:
a.
Use or scrolling key or the alphabetical
search method to locate the record to be erased or
edited.
b. Press OPTION (Right) soft key to enter editing
menu.
c. Press “1” to erase the desinated phone entry.
d.
LCD shown “Delete entry?” Press YES (Left) soft
key to confirm your change.
8. To edit phonebook:
a. Use or scrolling key or the alphabetical
search method to locate the record to be erased or
edited.
b. Press OPTION (Right) soft key to enter editing
menu.
c. Press “2” to edit the desinated phone entry.
Name?
_
Caps = *
SAVE DELETE
9. Dial
from display:
a. Press or to dial the phone number or Handset ID
displayed.
10. To transfer phonebook:
To transfer phonebook, both parties have to enter the phonebook transfer
mode firstly by following below:
a. Press OPTION follow by 5 or ¿ or À scrolling key when handset in
phonebook mode.
b. For phone sending party, press 1 to enter sending mode.
i. Either press TX ALL (left softkey) to transfer all phonebook entries
to another handset(s).
ii. Or press TX ONE (right softkey) to transfer one entry to another
handset(s).
iii. Press 2-digit handset ID or group ID, then select all phonebook
entries or one entry to be transferred.
~44~
Re : “00” means all handsets
iv. During phonebook transferring, LCD shows “Sending” and 2-digit
countdown on the LCD to indicate the phonebook numbers which
are waiting for sending.
c. For phonebook receiving party, press 2 to enter receiving mode.
i. When entering the receiving mode, LCD shows “Ready”.
ii. Start to receive phonebook, LCD shows “Get phonebook from
Ext. # : xx”.
iii. A beep emitted when receiving each phonebook.
iv. When the phonebook receiving, 2-digit countdown on the LCD to
indicate the phonebook numbers which are waiting for receiving.
Re: The phonebook transfer through the wireless interface, it may partially
miss transmission by interference.
Call Barring
1. Block the users from dialing the long distance calls or international calls.
And also block the incoming call from outside line or other registered
handset.
You need the password to enter the setting. The default PW is “0000”.
2. Press MENU -4-3 to enter Call Barring. Enter the
password, followed by OK (Left) soft key
Block Outgoing Call
1.
Press SELECT to confirm your selection.
2. Use or scrolling key to switch between On
and Off of this setting. Press SELECT to confirm your
selection.
Re：The default of Call Barring is “Off”.
3. To add the Call Barring code