Tascam RC-898 - Manual (Page 6)

Section 1.4 - Precautions and recommendations
1-2
cator [10] will light”. The number in brackets fol-
lowing the name of the control is the number of
the control as shown on the front panel illustra-
tion, as well as that used in the appropriate sec-
tions describing the front and rear panels.
A special font is used for showing the messages
that appear on the LCD display screen [11], for
example:
9Pin Locate Preroll .
When describing a value as shown on the TAPE
TIME [13], MEMORY NO [14], or LOCATE
TIME/VALUE [15] displays, the following font is
used: 00:23:45:12 or on .
Some functions of the RC-898 apply to all DTRS
recorders, some only to DA-98 units, some to DA-
38 units and some to DA-88 units with the SY-88
synchronizer board fitted. Wherever appropriate,
this manual will use combinations of the follow-
ing symbols to show what operations may be per-
formed with the different units in the DTRS range:
This manual may also make references to the
manuals of the DTRS units and the SY-88. In the
case of the DA-98 and DA-38, these references
will be made in terms of section numbers (e.g.
“4.2” and “4-5” respectively). In the case of the
DA-88 and SY-88, page numbers will be provided
(e.g. “p16” and “p5-7” respectively).
1.4 Precautions and
recommendations
As with every precision piece of electronic equip-
ment, common-sense precautions apply with the
RC-898.
However, you should note the following points in
particular with regard to the operation of the unit:
1.4.1 Environmental conditions
The RC-898 can be operated in most environ-
ments, but we suggest that you keep the environ-
mental conditions within the following limits:
• Ambient temperature between 5
°
and 35
°
C
(41
°
and 95
°
F).
• Relative humidity should be between 30% and
80% non-condensing
• Avoid spraying polish, insecticides, etc. near
the RC-898.
• Avoid subjecting the RC-898 to jolts, sudden
shocks, etc.
TASCAM does not accept responsibility for dam-
age resulting from neglect or accident.
1.4.2 Battery backup
The RC-898 requires no power supply of its own,
drawing its power from the DTRS units to which
it is connected.
Location memories and configuration settings are
stored using a battery backup system. The battery
should provide power for several years of use.
When the battery eventually degrades to the point
where it cannot provide enough power to retain
settings, the message
Memory Error will
be shown on the display screen (this can be
removed by pressing the
ESCAPE key).
When this message appears, all memories (loca-
tion memories and configuration settings) are
cleared and reset to the default settings.
If you see this message, contact your TASCAM
dealer for details of battery replacement. Do not
attempt to replace the battery by yourself.
1.4.3 Digital audio cables
When making connections between TASCAM
digital audio units, always use genuine TASCAM
cables. This applies particularly to any T-DIF dig-
Unit Symbol in text
All units No symbol
DA-88 with SY-88
DA-38
DA-98
88
38
98
WARNING
If you need to clean the unit, use a soft cloth, moistened if
necessary with a little detergent and water. Do not use abra-
sive cleaners or solvents such as alcohol or thinner.
WARNING
If you have to return the unit for service or repair, use the
original packing materials if possible. If the unit is to be
transported to a recording location, etc., use a suitable trans-
port case with sufficient shock protection.