Tascam RC-898 - Manual (Page 23)

Section 4.5 - Storing and recalling user setups
4-5
3) Highlight the Load field, and change it so that
it reads Save , using the UP key.
4) Use the LEFT and RIGHT keys to highlight the
user memory into which you wish to store the
current settings, and press the
UP key.
5) Press SELECT to confirm the save, or any of
the following: ESCAPE , DOWN , LEFT or
RIGHT keys to cancel.
The display will briefly show Execut-
ing... , and the current settings will be saved
into the user setup.
4.5.2 Recalling a user setup or restoring
factory settings
Any of the ten user setups, as well as the factory
defaults, can be recalled, using the screen above.
1) From the top screen, select menu group F, and
select the Setup menu:
2) Make sure that the left parameter shows
Load by moving the cursor under it, and the
DOWN key to change its value to Load from
Save .
3) Move the cursor under the user area (or
factory setting, represented by F ), and press
the UP key to recall the setup.
4) Press SELECT to confirm the load,or any of
the following: ESCAPE , DOWN , LEFT or
RIGHT keys to cancel
The selected user setup will replace the current
settings.
If you try to load from a setup into which data has
not been saved, the display will briefly show
No
Data , and the load operation will not take place.
S e t u p
A r e y o u s u r e ?
0
S a v e 1 2 3 4 5 6 7 8 9 F
S e t u p
L o a d 0 1 2 3 4 5 6 7 8 9 F
S e t u p
A r e y o u s u r e ?
0
L o a d 1 2 3 4 5 6 7 8 9 F