Tripp Lite B050-000 - Manual (Page 80)

Chapter 6. Menu Options
“bootp” accordingly. If you choose “none” then IP auto configuration is disabled.
Preferred host name
Preferred host name to request from DHCP server. Whether the DHCP server
takes the B050-000’s suggestion into account or not depends on the server con-
figuration.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the B050-000 should be accessible from networks other than the local one,
this IP address must be set to the local network router’s IP address.
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option may
be left empty, however the B050-000 will not be able to perform name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be used
in case the Primary DNS Server cannot be contacted.
Miscellaneous Network Settings
Remote Console And HTTPS port
Port number at which the B050-000’s Remote Console server and HTTPS server
are listening. If left empty the default value will be used.
HTTP port
Port number at which the B050-000’s HTTP server is listening. If left empty the
default value will be used.
Telnet port
Port number at which the B050-000’s Telnet server is listening. If left empty the
default value will be used.
SSH port
Port number at which the B050-000’s Secure Shell (SSH) server is listening. If left
empty the default value will be used.
Bandwidth Limit
The maximum network traffic generated through the B050-000 Ethernet device.
Value in Kbit/s.
Enable Telnet access
Set this option to allow accessing the B050-000 using the Telnet gateway (see the
Section called Telnet Console).
72