Tripp Lite B050-000 - Manual (Page 25)

Chapter 4. Configuration
Initial Configuration
The B050-000’s communication interfaces are all based on TCP/IP. It comes pre-
configured with the IP configuration listed in Table 4-1.
Table 4-1. Initial network configuration
Parameter Value
IP auto configuration DHCP
IP address -
Netmask 255.255.255.0
Gateway none
IP access control none
Warning
If the DHCP connection fails on boot up, the B050-000 will not have an
IP address.
If this initial configuration does not meet your requirements, the following describes
the initial IP configuration that is necessary to access the B050-000 for the first time.
B050-000 Setup Tool
The setup tool is used to determine the IP address assigned to the B050-000 by the
DHCP server or to change the device’s initial network configuration.
Main Window
Figure 4-1. B050-000 setup tool (Windows version)
17