Front side connectors (figure 12), Rear side connectors (figure 1-3), Front side connectors (figure 1-2) – Tripp Lite B050-000 User Manual

Page 10

Chapter 1. The Quick Start Guide

Front Side Connectors (Figure 1-2)

Figure 1-2. Front Side Connectors and Indicators

System port

Attach the system cable with the gray connector to this port.

Power/Status LED

Displays the status of the B050-000:

•

LED off: the B050-000 has no or not enough power

•

LED blinking: the B050-000 is booting up (if this process takes longer than one
minute, the reason may be a lack of power).

•

LED on: the B050-000 is up and running.

If the B050-000 is connected via USB only and the Power/Status LED tends not
to stop blinking after one minute, the B050-000 may not receive enough power
via USB. In that case attach the enclosed power supply to the B050-000.

Power supply DC 5V

Attach the enclosed power supply to the B050-000.

•

Voltage: 5V

•

Current: 1.5 A

RJ45 Ethernet

UTP3/5 cables can be connected to the B050-000 using this standard RJ45 jack.