Programming channels automatically – Toshiba 22AV500U User Manual

Page 30

Chapter 5: Setting up your TV

Programming channels into the

TV’s channel memory

When you press or on the remote control or TV
control panel, your TV will stop only on the channels you
programmed into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.

Note:

You must configure the antenna input source before

programming channels ( page 29).
If the Antenna input signal type is set to Cable, the

automatic channel programming process erases channels

that were previously programmed into the TV’s memory.
If the Antenna input signal type is set to Antenna, the

automatic channel programming process adds newly

found channels to the existing set of programmed channels

(and does NOT erase channels that were previously

programmed into the TV’s memory.) To remove an Antenna

source channel from the memory, you must manually delete

it.
To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the

remote control.
Programming channels when the antenna input is

configured for Cable will take substantially longer than

when the antenna input is configured for Antenna. This is

normal; however, once channel programming is finished,

you should not have to repeat the programming process

again unless your Cable TV service lineup changes

significantly.

To program channels automatically:

Configure the antenna input source, if you have not
already done so ( page 29).
Press

and open the

Setup menu.

Highlight

Installation and press .

•

1�

2�

3�

(A new set of

Installation menu icons will appear, as

shown below.) Open the

Terrestrial menu, highlight

Channel Program to bring up the Start, and press
again to begin channel programming.

The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message “Scanning channels, please wait” appears (as
shown above).

To cancel channel programming, press on the remote
control (or highlight

Cancel in the on-screen display and

press

When channel programming is finished, press or to
view the programmed channels.

Manually adding and deleting channels in

the channel memory

After automatically programming channels into the channel
memory, you can manually add or delete individual channels.

To add or delete channels in the channel memory:

Press