TurboChef Technologies 2020 HIGH h - Manual (Page 19)

ST
AND
ARD OVEN OPERA
TION
1 1
Editing a Cooking Profile
To edit a cooking profile, the oven must be in the
COOKING MODE and the full edit or flex option
must be enabled for each option to be edited. For
more information on selecting between full edit,
rigid, and flex options for each editable setting, see
Edit Options Screen on page 14.
When the rigid option is enabled for a given setting,
the soft key adjacent to that setting (Figure 9) is
disabled and no menu editing is allowed.
When the full edit option is enabled for a given
setting, that setting is fully customizable and
changes are saved once the oven returns to the
OVEN
OFF or COOLING DOWN MODE .
When the flex option is enabled for a given setting,
that setting is customizable within flex option
limitations (as described in the following sections),
and changes will reset when the oven returns to the
OVEN OFF or COOLING DOWN MODE . NOTE: The
flex option does not apply to editing a profile name.
This section assumes that the full edit option is
enabled (except where otherwise noted) and that a
cooking profile and belt speed have been selected.
Changing a Cooking Profile Name
1. From the cooking screen (Figure 9), press
L1 to access the name change screen
(Figure 10).
2. Change the name of the cooking profile.
- The up key moves up through the available
characters. e.g. A,B,C…
- The down key moves down through the
available characters e.g. A,+,-, ,9,8…
- INS (L1) inserts a space.
- DEL (R1) deletes the selected character.
- ---> (R1) moves the cursor to the right.
- <--- (L1) moves the cursor to the left.
3. Press save (R3) to save the changes or cancel
(L3) to cancel any changes.
PROFILE 1
BELT F
5:00
BELT R
3:20
TOP AIR 80 %
SET
COOKING
475F
BTM AIR 100 %
INS
CANCEL
DEL
<--- --->
SAVE
[PROFILE 1 ]
Figure 9: Cooking Screen Figure 10: Name Change Screen
L1
L2
L3
R1
R2
R3
L1
L2
L3
R1
R2
R3