Onkyo PR-SC886 - Manual (Page 122)

122
Controlling Other Components
You can control your other components, including those
made by other manufacturers, with the remote controller.
This section explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component’s
remote controller (see page 125).
• Program the MACRO buttons to perform a sequence
of up to eight remote control actions (see page 126).
To control another component, you must first enter that
component’s remote control code to a REMOTE MODE
button. You’ll need to enter a code for each component
that you want to control.
Notes:
• Remote control codes cannot be entered for the
[RECEIVER], [ZONE 2] and [ZONE 3] REMOTE
MODE buttons.
• The remote control codes provided are correct at the
time of printing but subject to change.
Entering Remote Control Codes
1 Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
REMOTE
MODE
TV
RECEIVER
STANDBY
I
Number
buttons
Remote
indicator
2 While holding down the REMOTE
MODE button to which you want
to enter the code, press the
[STANDBY] button.
The Remote indicator lights up.
3 Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote indicator flashes twice.
4 Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.
DVD
AUX 1 AUX 2 GAME/TV
CBL/SAT VCR/DVR
CD TUNER TAPE
0
1 2 3
4 5 6
7 8 9
• The [DVD] and [CD] REMOTE MODE buttons
are preprogrammed for use with Onkyo DVD
players and CD players, respectively.
• To control another manufacturer’s CD recorder,
MD recorder or Onkyo RI Dock, enter the appro-
priate remote control code to the [CD] REMOTE
MODE button.