Onkyo DV-BD606 - Manual (Page 8)

8 EN
FUNCTION OVERVIEW
(*) The unit can also be turned on by pressing these buttons.
1. STANDBY indicator
• This indicator lights up in red in standby mode and
turns off when the power is on.
2. Q ON/STANDBY button
• Press to turn the unit on or off.
3. Disc tray
• Place a disc when opening the disc tray.
4. A(open/close) button*
• Press to open or close the disc tray.
5. Display
• Refer to “Front Panel Display” on page 11.
6. F (pause) button
• Press to pause playback.
7. C (stop) button
• Press to stop playback.
8. B (play) button*
• Press to start or resume playback.
9. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
10. SD CARD slot
• Insert an SD Memory Card, and play back the
contents in it.
1. VIDEO OUTPUT (COMPONENT) jacks
• Use to connect a TV with component video inputs
with an RCA component video cable.
2. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port
with an HDMI cable.
3. AUDIO OUTPUT (ANALOG L/R) jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
4. AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL) jacks
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial/optical input jack with a digital audio
coaxial/optical cable.
5. AC INLET terminal
• Use to connect the AC outlet with the AC cord.
6. VIDEO OUTPUT (VIDEO) jack
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
Front Panel
ON/STANDBY
STANDBY
SD CARD
3 2 1 4* 5 9 6 7 8* 10
Rear Panel
VIDEO OUTPUT AUDIO OUTPUT
HDMI
R
L
OUT
COMPONENT
COAXIAL OPTICAL
AC INLET
(PCM//BITSTREAM)
ANALOG DIGITAL
Y PR
VIDEO PB
2 3 4 5 1
6
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
E5J50ED_EN.book Page 8 Wednesday, September 10, 2008 11:10 PM