Onkyo DV-BD606 - Manual (Page 31)

31
SPECIAL SETTINGS
EN
There are 2 ways to set “BD Audio Mode” setting; whether
to output the secondary and interactive audio
accompanied by the primary audio or only the primary
audio. Depending on the setting of the mode, Dolby
Digital, Dolby Digital Plus, Dolby TrueHD, DTS, or DTS-HD
output changes between multi LPCM and bitstream.
1 In stop mode with BD inserted, press [MODE].
2 Use [K / L] to select your desired setting.
• For “Secondary”, use [s / B] to switch between
current audio setting and “Off”.
“Mix Audio Output”:
If it is available, BD-video’s secondary and interactive
audio will be output with the primary audio.
• The secondary audio is the audio for the secondary
video (Director’s comment etc.) and the interactive
audio is the audio for the interactive application
(Button click sounds etc.).
“HD Audio Output”:
Only the primary audio will be output. Set this mode in
order to output Dolby Digital, Dolby Digital Plus, Dolby
TrueHD, DTS or DTS-HD audio of BD through HDMI
connection.
3 Press [RETURN] to exit.
• You can also set “BD Audio Mode” from the setup
menu. Refer to page 37.
You can adjust the picture quality.
1 During playback, press [MODE].
2 Use [s / B] to adjust the setting.
S Noise reduction
Reduces the noise of the playback picture.
3 Press [RETURN] repeatedly to exit.
Setting the BD Audio Mode
Note
• In “Mix Audio Output” mode, if there is no secondary
and interactive audio, the audio will be output as
“HD Audio Output” mode.
• In “Mix Audio Output” mode, even if you set “HDMI
Multi(Normal)” in “HDMI Audio Out” setting, multi
LPCM will be output from HDMI OUT jack for BD
audio. Refer to page 14.
• In “Mix Audio Output” mode with HDMI audio being
output, 2-channel down-mixed LPCM will be output
from AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL)
jack for BD audio.
• In “Mix Audio Output” mode with “HDMI Audio Out”
setting set to “Audio Mute” and “Digital Out” setting
set to “Bitstream”, DTS, DTS-HD and LPCM will be
output as Dolby Digital for BD audio. Refer to
pages 14, 16.
• You can also set “BD Audio Mode” setting from the
setup menu. Refer to page 37.
BD-V
BD Audio Mode Mix Audio Output
Adjusting the Picture
“Off”: Shows the original picture as recorded.
“1”:
Executes MPEG noise reduction which reduces
the block noise and mosquito noise on the
subtitle on movie.
“2”: Executes 3D noise reduction which detects and
deletes the noise by comparing each picture
frames.
“3”: Executes both MPEG noise reduction and 3D
noise reduction.
Note
• The setting remains even if you turn off the unit.
• For BD, noise reduction is not effective.
DVD-V DivX
s B Noise Reduction Off
E5J50ED_EN.book Page 31 Wednesday, September 10, 2008 11:10 PM