Onkyo DV-BD606 - Manual (Page 16)

16
CONNECTIONS
EN
S Audio signals output from AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL) jacks
The audio signals currently output from HDMI OUT jack will be output from AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL)
jacks as well, except that Dolby Digital signal will be output instead of Dolby Digital Plus and Dolby TrueHD, and DTS
signal will be output instead of DTS-HD.
When “Audio Mute” is selected in “HDMI Audio Out” setting, audio signals output from HDMI OUT jack will be muted and
the audio signals output from AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL) jacks change depending on “Digital Out”
setting.
To set “Digital Out” setting, select “Audio Mute” in “HDMI Audio Out” setting.
* For BD titles with secondary or interactive audio, these audio will be output as Dolby Digital when all the conditions
listed below are met:
• When “BD Audio Mode” setting is set to “Mix Audio Output”.
• When “HDMI Audio Out” setting is set to “Audio Mute”.
• When “Digital Out” setting is set to “Bitstream”.
If BD titles do not have secondary or interactive audio, the audio will be output as shown in the table.
• This table applies only when HDMI cable is not connected or “Audio Mute” is selected in “HDMI Audio Out” setting.
After you made all necessary connections, connect the AC cord to the AC INLET. Then connect the AC cord to the AC
outlet.
Insert the plugs securely. Incomplete connections will result in the generation of noise.
Disc type Audio recording format
“Digital Out” setting
Bitstream LPCM
BD-video
Dolby Digital Dolby Digital 2ch Downmix LPCM
Dolby Digital Plus Dolby Digital 2ch Downmix LPCM
Dolby TrueHD Dolby Digital 2ch Downmix LPCM
DTS DTS* 2ch Downmix LPCM
DTS-HD DTS* 2ch Downmix LPCM
LPCM 2ch Downmix LPCM* 2ch Downmix LPCM
DVD-video
Dolby Digital Dolby Digital 2ch Downmix LPCM
DTS DTS 2ch Downmix LPCM
LPCM 2ch Downmix LPCM 2ch Downmix LPCM
MPEG MPEG Multi LPCM
DivX ®
Dolby Digital Dolby Digital Multi LPCM
MP3 / MP2 2ch LPCM 2ch LPCM
audio CD/ MP3 2ch LPCM 2ch LPCM
DTS-CD DTS 2ch Downmix LPCM
Note
• In order to output LPCM signal from AUDIO OUTPUT (DIGITAL COAXIAL/OPTICAL) jacks while outputting the HDMI
audio signal, set “BD Audio Mode” setting to “Mix Audio Output” and set “HDMI Audio Out” setting to “HDMI
Multi(LPCM)”.
Connecting the AC Cord
AC INLET AC cord
AC110-240V, 50Hz
this unit
AC outlet
Supplied cables used in this connection are as follows:
• AC cord x 1
E5J50ED_EN.book Page 16 Wednesday, September 10, 2008 11:10 PM