Onkyo DV-BD606 - Manual (Page 4)

4
PRECAUTIONS
EN
, ).
• Do not use this unit when there’s the possibility
of moisture condensation occurring. Doing so
may damage your discs and certain parts inside
this unit.
If condensation does occur, remove all discs and
leave this unit turned on for two to three hours. By
this time, the unit will have warmed up and any
condensation will have evaporated.
12. Region Codes—The BD/DVD standard uses
region codes to control how discs can be played
around the world, the world being divided into
three regions (BD) or six regions (DVD). This unit
will only play BD/DVD discs that match its region
code, which can be found on its rear panel (
13. About this Manual—This manual explains how
to use all of this unit’s functions. Although the
BD/DVD standard offers many special features, not
all discs use them all, so depending on the disc
being played, this unit may not respond to certain
functions. See the disc’s sleeve notes for supported
features.
This unit contains a semiconductor laser system and is
classified as a “CLASS 1 LASER PRODUCT”. So, to use this
model properly, read this Instruction Manual carefully.
In case of any trouble, please contact the store where
you purchased the unit.
To prevent being exposed to the laser beam, do not try
to open the enclosure.
DANGER:
VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN
AND INTERLOCK FAILED OR DEFEATED. DO NOT STARE
INTO BEAM.
CAUTION:
THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS
OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
The label on the right is applied
on the rear panel.
1. This unit is a CLASS 1 LASER
PRODUCT and employs a laser inside
the cabinet.
2. To prevent the laser from being exposed, do not
remove the cover. Refer servicing to qualified
personnel.
2
For British models
IMPORTANT
Blue: Neutral
Brown: Live
For European Models
Replacement and mounting of an AC plug on
the power supply cord of this unit should be
performed only by qualified service personnel.
The wires in the mains lead are coloured in
accordance with the following code:
As the colours of the wires in the mains lead of
this apparatus may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black. The wire which is
coloured brown must be connected to the
terminal which is marked with the letter L or
coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the
fuse needs to be replaced, the replacement fuse
must approved by ASTA or BSI to BS1362 and
have the same ampere rating as that indicated
on the plug. Check for the ASTA mark or the BSI
mark on the body of the fuse.If the power cord’s
plug is not suitable for your socket outlets, cut it
off and fit a suitable plug. Fit a suitable fuse in
the plug.
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
K. MIYAGI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
E5J50ED_EN.book Page 4 Wednesday, September 10, 2008 11:10 PM