Olympus PT-019 - Manual (Page 14)

E-13
Setting the Zoom Lever
When loading the digital camera
in the Case, fit the projecting
part of the zoom lever of the
digital camera into the recessed
part of the zoom lever on the
inside of the Case.
Note: • When the set time (initial setting: 3 minutes) passes without
any operation while the digital camera is installed in
shooting mode, the camera enters into sleep mode (standby
status) and the operation stops.
To cancel sleep mode (return to operation status), press the
shutter button or any other button.
For details, refer to the instruction manual for the digital
camera.
Power Switch Operation Method
Power switch operation is
possible by operating the
power switch lever of this
Case corresponding to the
power switch lever of the
digital camera in the Case.
: • When loading the camera, confirm that the projecting
part of the zoom lever of the camera is properly set to
the recessed part of the zoom lever of the Case.
• When the setting is insufficient, the loading of the
camera becomes imperfect and it may not be
possible to seal the Case or zooming may not
function. Insufficient sealing will cause water leakage.
CAUTION