Onkyo HT-R510 - Manual (Page 5)

5
Before Using the HT-R510
Notes:
• The supplied batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replacing
both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
• Flat batteries should be removed as soon as possible to pre-
vent possible leakage and corrosion.
To use the remote controller, point it at the HT-R510’s
remote control sensor, as shown below. The HT-R510’s
STANDBY indicator flashes while a signal is being received
from the remote controller.
Notes:
• The remote controller may not work reliably if the
HT-R510 is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in mind
when installing the HT-R510.
• If another remote controller of the same type is used in the
same room, or the HT-R510 is installed close to equipment
that uses infrared rays, the remote controller may not work
reliably.
• Don’t put anything, such as a book, on the remote control-
ler, because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the
HT-R510 is installed in a rack behind colored glass doors.
Keep this in mind when installing the HT-R510.
• The remote controller will not work if there’s an obstacle
between it and the HT-R510’s remote control sensor.
Installing the Batteries
1 Open the battery compartment, as shown.
2 Insert the two supplied batteries (AA/R6) in
accordance with the polarity diagram inside
the battery compartment.
3 Close the battery compartment.
Using the Remote Controller
30˚
30˚
HT-R510
Remote control sensor
Standby indicator
Appr
ox
. 16 ft.
(5 m)