beautypg.com

Parental lock – Onkyo HT-S5200 User Manual

Page 58

background image

58

Listening to SIRIUS Satellite Radio

—Continued

You can lock out channels that you do not want to
receive.

*

The default number is “0000.” If you want to change the default
setting, see “Changing the PIN Number” on page 59.

To unlock a previously locked channel, select the
locked channel (see step 1–4), press the Left and Right
[

]/[

] buttons so that the asterisk disappears (see step

5), and then press [ENTER]. The message “Unlocked”
will appear on the display.

2

Use the Up and Down [ ]/[ ]
buttons to select “9. Antenna
Aim,” and then press [ENTER].

Note:
If the “SATRadio” is set to “None” (see
page 53), the “Antenna Aim” item is
not available.

3

Adjust the position of the
indoor/outdoor antenna
connected to the SiriusConnect
receiver so that the satellite
(SAT) signal strength bar is as
long as possible.

If you cannot receive a satellite signal,
press the Down [ ] button to display
the terrestrial (TER) signal strength
meter and adjust your antenna so that
the bar is as long as possible.
Terrestrial signals are only available in
certain areas.

So long as the signal strength is good,
you can enjoy SIRIUS Satellite Radio
by using either satellite or terrestrial
reception.

Parental Lock

1

Press the [RECEIVER] button,
followed by the [SETUP] button.

2

Use the Up and Down [ ]/[ ]
buttons to select “10. Parental
Lock”, and then press [ENTER].
“Enter : <0>” appears on the display.

Note:
If the “SATRadio” is set to “None” (see
page 53), the “ParentalLock” item is
not available.

3

Use the Left and Right [

]/[

]

buttons to change the number
displayed between the angle
brackets < >, and then press
[ENTER]. Repeat this for each
digit in the PIN number.*

4

Use the Up and Down [ ]/[ ]
buttons to select the channel that
you want to lock out, for
example:

5

Press the Left and Right [

]/[

]

buttons so that an asterisk
appears next to the name, as
shown below, and then press
[ENTER].

The message “Locked” will appear on
the display.

6

Press the [SETUP] button.
Setup closes.

HT-S5200_En.book 58 ページ 2009年3月9日 月曜日 午後4時31分