Onkyo HT-S5200 - Manual (Page 21)

21
Connecting the AV receiver
—Continued
The speakers can easily be wall mounted by using the
keyhole slots.
To mount the front or surround speakers vertically, use
the keyhole slot shown to hang each speaker on a screw
that’s securely screwed into the wall.
Front speakers (SKF-570)
Surround speakers/Surround back speakers
(SKR-570/SKB-570)
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two screws
that are securely screwed into the wall.
Center speaker (SKC-570)
Caution:
A mounting screw’s ability to support a speaker depends
on how well it’s anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 5/16" (8 mm) or less
and a shank diameter of 5/32" (4 mm) or less. With
hollow walls, use a cable/pipe detector to check for any
power cables or water pipes before making any holes.
Leave a gap of between 7/32"
(5 mm) and 3/8" (10 mm)
between the wall and the base
of the screw head, as shown.
(We recommend that you
consult a home installation
professional.)
We recommend using the provided rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving,
providing a more stable platform. Use thick stoppers for
the center speaker.
If the subwoofer is placed on a hard floor (wood, vinyl,
tile, etc.) and playback is very loud, the subwoofer’s feet
may damage the flooring. To prevent this, place the
supplied pads underneath the subwoofer’s feet. The pads
also provide a stable base for the subwoofer.
Wall Mounting
Keyhole slot for wall
mounting
Keyhole slot for wall
mounting
Keyhole slot for wall mounting
7-7/8" (200 mm)
Using the Rubber Stoppers for a
More Stable Platform
Using the Floor Pads for Subwoofer
Wall
7/32" – 3/8"
(5 mm) – (10 mm)
Thick rubber stoppers
Bottom of the
SKC-570
Pad
HT-S5200_En.book 21 ページ ２００９年３月９日 月曜日 午後４時３１分