Onkyo HT-S5200 - Manual (Page 41)

41
First Time Setup
—Continued
Note:
When the room correction and speaker setup is
complete, “6. Equalizer” (page 72) will be set to
“Audyssey.”
Error Messages
While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high
This message appears if there’s too much background
noise and the measurements cannot be performed
properly. Remove the source of the noise and try again.
❏ Speaker Detect Errors
This message appears if one of the speaker-related errors
below occurs.
• One of the front speakers has not been detected.
• One of the surround speakers has not been detected.
❏ Write Error
This message appears if saving fails.
❏ Mismatch Error
This message appears if a speaker that was detected
during the 1st measurement is not detected during the
2nd or 3rd measurements. If this message appears, check
your speaker connections, and then try again.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the room correction and speaker setup, follow the
directions on pages 70–72.
Using a Powered Subwoofer
If you’re using a powered subwoofer, as it outputs very
low-frequency sound and its position is usually low
down, it may not be detected by the Audyssey 2EQ
Room Correction and Speaker Setup. In this case,
increase the subwoofer’s volume, select its highest
crossover frequency, and then try running the
Audyssey 2EQ Room Correction and Speaker Setup
again. Note that if the volume is set too high and the
sound distorts, it may not be detected, so use an
appropriate volume level.
5 When the following display appears,
move the speaker setup microphone to
measurement point
(page 39), and
then press [ENTER].
Audyssey 2EQ
™
performs more
measurements.
This takes a few minutes.
When the measurements are complete, the
results are calculated and saved automatically.
6 When the room correction and speaker
setup is complete, disconnect the
speaker setup microphone.
To Retry the Room Correction and
Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be
detected are connected properly.
HT-S5200_En.book 41 ページ ２００９年３月９日 月曜日 午後４時３１分