Oki MC160n - Manual (Page 43)

43 Control Panel and Configuration Menu
KEY
SPEED TIME TO
START Setting 0.1sec / 0.3sec / 0.5sec / 1.0sec /
1.5sec / 2.0sec / 2.5sec / 3.0sec
Specify the length of time until the cursor
begins to move continuously when a key is
held down.
INTERVAL Setting 0.1sec / 0.3sec / 0.5sec / 1.0sec /
1.5sec / 2.0sec / 2.5sec / 3.0sec
Specify the length of time until the cursor con-
tinuously moves between settings or charac-
ters.
LANGUAGE Setting ENGLISH / FRENCH / GER-
MAN / ITALIAN / SPANISH /
PORTUGUESE / RUSSIAN /
CZECH / HUNGARIAN / POL-
ISH
Select the language of the menus and mes-
sages that appear in the message window.
BUZZER VOLUME Setting OFF / LOW / HIGH
Select the volume of the sound produced
when a key is pressed and of the alarm that is
sounded when an error occurs.
INITIAL MODE Setting COPY / FAX
Specify the default mode when the machine is
turned on or when all settings in the control
panel return to their default settings.
TONER OUT STOP Setting ON / ON(FAX) / OFF
Select whether or not printing, copying and
faxing stop when the toner has run out.
If ON is selected, printing, copying and faxing
stop when the toner runs out.
If OFF is selected, printing, copying and faxing
continues even if toner has run out.
Printing, copying and faxing can continue,
however, the printing results are not guaran-
teed. If printing, copying and faxing are contin-
ued, the message TONER LIFE END/
CHANGE X TONER appears and printing
stops.