One for All URC-7541 - Manual (Page 9)

Setting up your Digital Satellite
System
To set up the ONE FOR ALL 4 Digital for your Digital Satellite
System, follow the instructions below.
Inside this manual you will find a package
containing several adhesive overlays.
Open the package and locate the correct overlay
referring to your brand. Make sure your Digital
Satellite System is switched on.
Press and release the SAT key.
Press and hold down the MAGIC key until the
device key blinks twice (the device key will blink
once, then twice).
Enter the four-digit SAT code which you will
find on the overlay corresponding to your brand.
The device key will blink twice.
Now aim your ONE FOR ALL 4 Digital at your
Digital Satellite System and press POWER. If your
device switches off, your ONE FOR ALL 4 Digital
should be ready to run your Digital Satellite
System.
Turn your device back on and try all the remote’s functions.
Write your code in the four boxes provided in the battery
compartment and on page 11 for easy future reference.
The ONE FOR ALL 4 Digital should now operate your Digital
Satellite System.
- Remove the temporary paper overlay over the eight keys at the
bottom of the remote.
- Take the adhesive overlay corresponding to your brand.
- Peel off the transparent protective cover from the front.
- Peel off the backing sheet.
- Stick the overlay in its place over the eight keys at the bottom
of the remote.
Installation
W W W.ONEFORALL.COM
7
tv guide box office services interactive
backup i help i SKY
S0847 BskyB
1
2
3
5
6
7
8
4
_ _ _ _
Example