One for All URC-7541 - Manual (Page 4)

Quick Set-Up
The instructions below and on the next page can be
used to quickly install your new ONE FOR ALL.
You can use the Quick Set-Up below with the codes
listed on pages 11-23. If this doesn’t work, try the
Quick Search on the next page. The Quick Search can
also be used even if your brand is not listed at all.
Make sure you install the batteries in your ONE
FOR ALL before following the instructions below.
Make sure your device is switched on (not in
standby).
Press device key:
Press and hold until the
device key blinks twice (the
device key will blink once and
then twice). Then release.
Enter
(4-digit code). See pages 11-
23. The device key will blink
twice.
Aim remote at your device and
press
(or PLAY).
1.
2.
4.
3.
or or
_ _ _ _
2
NOTES:
- To set up your Digital Satellite System
please enter the four-digit code found at
the bottom of the adhesive overlay next to
the brand name.
- The instructions above are a “Quick” set-up
guide. For further explanation, please refer
to the pages within.
- Make sure you write your Set-Up codes in
the boxes provided on page 11 and inside
the battery compartment for easy future
reference.