Source connection, Remote mode setup, Network connection – Onkyo AV RECEIVER HT-RC460 User Manual
Page 21: Terminating the initial setup
Turning On & Basic Operations
En-21
This step checks the connection of source components.
With this step, you can enter remote control codes for the
components you want to operate.
This step checks your network connection.
This step ends the initial setup process.
Source Connection
1
Use / to select one of the following options, and
then press
ENTER.
`
Yes, Continue:
Performs the checkings.
`
No, Skip:
Skips this step and continues to “Remote Mode
Setup”.
2
Select the input selector for which you want to
check the connection and press
ENTER.
The picture of the corresponding source should appear
on screen with a verification prompt.
3
When prompted, use / to select one of the
following options and then press
ENTER.
`
Yes:
Confirms that the source is properly displayed.
`
No:
Displays an error report. Follow the
troubleshooting instructions and recheck the
source.
4
Use / to select one of the following options, and
then press
ENTER.
`
Yes:
Returns to step 2.
`
No, Done Checking:
The setup wizard continues to “Remote Mode
Setup”.
Remote Mode Setup
1
Use / to select one of the following options, and
then press
ENTER.
`
Yes:
Performs the remote control code input. Refer to
step 5 of “Looking up for Remote Control
Codes” (
).
`
No, Skip:
Skips this step and continues to “Network
Connection”.
2
When you’re finished, select one of the following
options and press
ENTER.
`
Yes, Done:
The setup wizard continues to “Network
Connection”.
`
No, not yet:
You can enter other remote control codes.
Network Connection
1
Use / to select one of the following options, and
then press
ENTER.
`
Yes:
Performs the checkings.
`
No, Skip:
Skips this step and terminates the initial setup.
Note
• If you use both wired and wireless network connections, the
wireless will take priority.
For further details, see the instruction manual provided with
your wireless device.
2
Follow the instructions on screen to perform the
network checking.
The checking is complete when the message
“Successfully connected.” appears at the middle of
the screen. Press ENTER to terminate the initial
setup.
3
If an error message appears, select one of the
following options and press
ENTER.
`
Retry:
Performs the checking again.
`
No, Do it Later:
Skips this step and terminates the initial setup.
The setup wizard goes to “Terminating the
Initial Setup”.
Terminating the Initial Setup
1
Press
ENTER.
To restart the initial setup, select “Initial Setup” in
the “Hardware Setup” menu (
).