Omega 24 - Manual (Page 19)

eg.RECALL 3
RECALL 5
RECALL 2
etc.
4. To return the meter to the operate mode, depress OPR after recalling the last reading. All
active location annunciators will turn on again, together with the OPR annunciator.
NOTE: Recalling data from unused (ie, empty) locations will give a zero reading.
To Erase Data Locations (Meter Mode):
1. Individual data locations can be erased by recalling the location to be cleared, followed
by a CLEAR key input. Note that the annunciator for the cleared location is turned off,
and the meter returns to OPR.
eg.RECALL 3
CLEAR
NOTES: There is no need to clear a location if new data is ready
for saving in this location. Just STORE the new data. It will write
over and delete the old.
6. CALIBRATOR MODE OPERATION (Thermocouples)
Set-Up:
1. Turn on the instrument by depressing the ON/OFF key.
2. Check that the BAT annunciator turns off after display check. If not, refer
to Battery Installation/Replacement instructions.
3. When operating as a calibrator, the display indicates CALIB. Should the
instrument be in the METER mode, hit the CALIB key to change to the calibrator function.
4. Select the thermocouple type that will be used.
NOTE: Space and legibility constraints on the display preclude
the use of dedicated annunciators for the less common tungsten-
rhenium thermocouple types (G, C, & D). Instead, these types are
annunciated momentarily on the alpha-numeric display when first
selected. Both T and R annunciators remain on to indicate a
Tungsten-Rhenium selection. To recall the actual G, C, D selection, turn
the unit off, then on again for another momentary readout.
5. Select the desired temperature scale (°F/°C key).
17