Oricom M5500 Series - Manual (Page 38)

CORDLESS HANDSET OPERATION
36
Cordless handset keypad lock
During standby mode,
1
. Press and hold # key to lock the keypad.
2
. To release keypad lock, press and hold # key
for 3 seconds.
Note
: When the keypad is lock, key and INT key can be used to answer an
external or intercom call.
Registration
HANDSET
1
Register new handsets on the M5500 base
Before you can use new handsets. You need to
1 . Charge the batteries (for 15 hours).
2 . Register the handset (to the base unit).
Each handset can register to four base at a time. Each base can register up to 4
handsets.
During standby mode,
1
. Press key.
2
. Press or key to select “REGISTER”
from the display.
3
. Press key. The display on the right is shown.
4
. Press the numeric keys to enter the base number.
5
. Press key to confirm.
6
. Press and hold key. The base is now in the registration mode.
7
. Press the numeric keys to enter the default PIN (0000).
8
. Press key to confirm and return to standby mode.
Note:
If the base is full and cannot add any more handsets, you will hear a tone.
See the next section to remove a handset.
REGISTER
BS ?