Oricom M5500 Series - Manual (Page 13)

11
BASIC OPERATION
Basic Operation
During standby
Cordless handset's LCD display
HANDSET 1 : Handset number
: Current battery level
: Signal icon indicates the
cordless handset is linked to the base unit.
Base unit’s LCD display
CLIP 10-30 : Total 30 calls with 10 new calls
A1 : OGM 1
Message15/35 : Total 35 messages with 15 new
messages
Answering an incoming call
Note: If the power is not connected to the base unit.
The cordless handset CANNOT operate. However, you can still
make and receive a call using the corded handset.
HANDSET
With cordless handset
When there is an incoming call, the phone rings and flashes on the display. If a CID
record is received,
flashes and the caller information is displayed.
1
. Press key to answer the call.
2
. Press key again to end the call.
With base unit
When there is an incoming call,
1
. Press key or pick up the handset to answer the call.
2
. Press key again or hang up the handset to end the call.
Note: Call timer shows the duration of your current call on the display.