Ositech comm Trumpcard Data/Fax Modem - Manual (Page 47)

User’s Guide and Reference 4 - 15
Modem Command Reference
Examples
ATSn Establishes S-register n as the default register
ATSn=x Set S-register n to the value x
ATSn? Reports the value of S-register n
T — Set Tone Dial as Default
Parameters: none
Default: none
Causes the modem to assume that all subsequent dial commands are
tone dialled. The user may omit the “T” from the dial string.
Vn — Result Code Form
Parameters 0 or 1
Default 1
Selects whether the modem returns long form or short form result codes.
All responses are ASCII values. Long-form (verbose) responses are
preceded and terminated with both carriage return and line feed control
characters. Short-form (numeric) responses are only terminated with a
carriage return control character (see Xn command).
Examples
ATV0 Allows short-form (numeric) result codes to be sent.
ATV1 Allows long-form (verbose) result codes to be sent.
Wn — Connect Message Control
Parameters 0, 1, or 2
Default 0
This command controls which message(s) are reported upon connection.
These messages can also be reported in either numeric or verbose form.
For example, both 77 and PROTOCOL:LAP-M indicates that the error-
correction protocol is LAP-M. (See Xn command.)
Examples
ATW0 Upon connection report CONNECT XXXX only
ATW1 Upon connection report CARRIER XXXX,
PROTOCOL XXXX and CONNECT XXXX
ATW2 Upon connection report CONNECT XXXX only