Onkyo TX-SR8360 - Manual (Page 75)

75
Zone 2 —Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Setting the Powered Zone 2
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “0. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
2, 3
2
1, 4
1
RECEIVER
ENTER
ENTER
3 Use the Up and Down [ ]/[ ]
buttons to select “g. Powered
Zone 2,” and use the Left and
Right [
]/[ ] buttons to select:
Not Activated: Zone 2 SPEAKERS
terminals deactivated.
Activated: Zone 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see page 76), the speakers connected
to the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals do not (when
Zone 2 is activated but not used, the
surround back speakers work as nor-
mal).
4 Press the [SETUP] button.
The setup menu closes.
ENTER