Onkyo TX-SR8360 - Manual (Page 24)

24
Connecting the AV Receiver —Continued
This section explains how to connect the supplied indoor
FM antenna and AM loop antenna, and how to connect
commercially available outdoor FM and AM antennas.
The AV receiver won’t pick up any radio signals without
any antenna connected, so you must connect the antenna
to use the tuner.
Connecting the Indoor FM Antenna
The supplied indoor FM antenna is for indoor use only.
If you cannot achieve good reception with the supplied
indoor FM antenna, try a commercially available out-
door FM antenna instead (see page 25).
Connecting the AM Loop Antenna
The supplied indoor AM loop antenna is for indoor use
only.
If you cannot achieve good reception with the supplied
indoor AM loop antenna, try using it with a commer-
cially available outdoor AM antenna (see page 25).
Connecting Antenna
1 Attach the FM antenna, as shown.
■ North American Model
■ Other Models
Once your AV receiver is ready for use, you’ll
need to tune into an FM radio station and adjust
the position of the FM antenna to achieve the best
possible reception.
2 Use thumbtacks or something similar to
fix the FM antenna into position.
Caution: Be careful that you don’t injure yourself
when using thumbtacks.
FRONT SPEAKERS
CENTER SPEAKER
SURROUND BACK SPEAKERS SURROUND SPEAKERS
FRONT SURROUND CENTER
CD VIDEO 3
VIDEO 3
VIDEO 2
VIDEO 2
VIDEO 1
VIDEO 1
IN OUT
OUT
IN IN OUT OUT
TAPE SUB WOOFER
MONITOR OUT
COAXIAL
OPTI- CAL
DVD
DVD
IN IN IN IN OUT OUT
IN IN
R
L
R
L
R
L IN 1
IN 1
IN 2
IN 1
IN 2 IN 3 OUT COMPONENT VIDEO
REMOTE CONTROL
IN 2
IN 3
DIGITAL
V
S
PB
Y
PR
ZONE 2 SPEAKERS
IR IN 12 V TRIGGER OUT ZONE 2
ANTENNA FM 75 AM
PRE OUT ZONE 2 LINEOUT
SUB WOOFER
R
L
AV RECEIVER MODEL NO. TX-SR 603E
L
R
AM antenna push terminals
FM antenna connector
Insert the plug fully
into the jack.
Insert the plug fully
into the jack.
Thumbtacks, etc.
1 Assemble the AM loop antenna, inserting
the tabs into the base, as shown.
2 Connect both wires of the AM loop
antenna to the AM push terminals, as
shown.
(The antenna’s wires are not polarity sensitive, so
they can be connected either way around).
Make sure that the wires are attached securely and
that the push terminals are gripping the bare
wires, not the insulation.
Once your AV receiver is ready for use, you’ll
need to tune into an AM radio station and adjust
the position of the AM antenna to achieve the best
possible reception.
Keep the antenna as far away as possible from
your AV receiver, TV, speaker cables, and power
cords.
Push Insert wire Release