Onkyo TX-SR8360 - Manual (Page 37)

37
Connecting the AV Receiver —Continued
With (Remote Interactive) you can control your
-compatible Onkyo CD player, DVD player, and so
on with the AV receiver’s remote controller, as follows:
• To use , you must make an analog audio con-
nection between the AV receiver and the other AV
components, even if they are connected digitally.
Auto Power On/Standby
When you start playback on an AV component con-
nected via
, if the AV receiver is in Standby, it will
turn on and select that AV component as the input source
automatically. Similarly, when the AV receiver is set to
Standby, all components connected via
also enter
Standby. Note that this function will not work if the com-
ponent’s power cord is connected to the AV receiver’s
AC OUTLET.
Direct Change
When playback is started on an AV component con-
nected via
, the AV receiver automatically selects
that AV component as the input source.
Remote Control
You can control your -compatible Onkyo compo-
nents with the AV receiver’s remote controller.
Notes:
• If you connect an -compatible Onkyo MiniDisc
recorder or CD recorder to the TAPE IN/OUT jacks,
for
to work properly, you must change the
TAPE/MD/CDR display (see page 52).
• Push plugs in all the way to make good connections.
• Use only
cables for connections. No
cables are supplied with this AV receiver.
• Some AV components have two jacks. You can
connect either one to this AV receiver. The other jack
is for connecting more
-compatible components.
• Connect the AV receiver’s jack to only Onkyo AV
components. Connecting to other manufacturer’s AV
components may cause them to malfunction.
• Some components may not support all functions.
Refer to the manuals supplied with your components.
The AV receiver has an AC outlet on its rear panel for
connecting the power cord of another AV component.
The other component’s power switch can then be left in
the ON position so that it turns on or off when the AV
receiver is set to On or Standby.
Caution:
Make sure that the capacity of the component that you
connect to the AC OUTLET does not exceed the stated
capacity (e.g., 100 W).
Notes:
• Onkyo components with jacks should be con-
nected directly to wall outlets, not the AV receiver’s
AC OUTLET.
• The socket type and capacity will depend on the coun-
try in which you purchased the AV receiver.
Connecting Components
REMOTE
CONTROL
L
R
IN
L
R
L
R
AUDIO
OUTPUT
AUDIO
OUTPUT
L
R
IN
e.g., DVD player
e.g., MD recorder
Connecting the Power Cord of
Another Component
AC OUTLET
AC 120 V 60 Hz
SWITCHED
120W 1A MAX.
European and some
Asian models North American
model