Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 49)

4.3.6 Configuration (continued)
PID: The Personal Network ID is automatically detected and displayed.
Channel: Choose the operation channel defined in IEEE 802.15.4 for the sensor
network. This allows you to select a wireless channel to communicate with the End
Devices. It is strongly suggested to let the Coordinator to search for the best channel
automatically, and by not touching this field.
Transmission Power: This determines the signal power transmitted by the Coordinator.
The options are 10 dBm and 20 dBm.
Refer to your local regulations for the allowed maximum transmission power.
Save: Saves changes for Channel and Transmission Power.
Radio Reset: Power resets the radio module in the Coordinator.
Radio Version: Firmware version of the radio module, also shown on model/serial label.
4.3.7 Sensor Setup
Click on from the Home Page, the following page will appear. Select the
proper Group.
Figure 4.15 Sensor Setup by Group
The Sensor Setup Page is for configuring End Device parameters such as name and
update rate.
A faster update period consumes more energy and creates more traffic. The
update time must be selected to satisfy acceptable network performance and
desired battery lifetime.
Sensor Setup
SENSOR SETUP: BY GROUPS
SENSOR SETUP
http://192.168.1.200 Address
Main Menu
Wireless Sensors ID: 0 - 7
Wireless Sensors ID: 8 - 15
Wireless Sensors ID: 16 - 23
Wireless Sensors ID: 24 - 31
Sensor Setup
Group A
Group B
Group C
Group D
43