Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 11)

PART 2 HARDWARE
2.1a Parts of the End Device (zED-P/-LCD/-AA)
1 8 position DIP switch (under cover), sets the NID and DID of the End Device
(see Section 2.7 for details)
2 Power Switch
3 Label for Unit Address, Group No. and Network ID Address (NID)
4 Wall mounting holes
5 Label with model and serial numbers
6 Radio module firmware revision location on label
7 Case’s tray, where the PCB, sensor and batteries are mounted
8 Case’s cover
9 Transmit LED (blue)
10 4 Screws attaching Cover
11 External probe/sensor, through cable gland (for zED-TC-x) or quick
disconnect connector
. Refer to Figure 2.2a for connector configurations.
12 Power Input, through quick disconnect connector (for zED-P & zED-LCD)
13 Antenna Mount
14 Thermocouple (if ordered) removable terminal block connector (under cover)
15 LCD Display (for zED-LCD & zED-LCD-AA)
16 Two AA alkaline batteries (for zED-LCD-AA) or one lithium back-up battery
(for zED-P & zED-LCD) (located under cover)
Figure 2.1a Parts of the End Device (zED-P/-LCD/-AA)
POWER
INPUT
5 VDC
SENSOR
INPUT
MODEL #
SERIAL #
#.#
5
6
8 7
2
9
10
15
11
12
Unit Addr Group Net. Addr
FRONT REAR
1
3
4
13 14
+ -
+ -
16
Warning:
the following parts are
ESD sensitive.
5