Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 26)

20
2.5 Parts of the Coordinator (continued)
17 Diagnostics LED: (Yellow and Green) Diagnostics: at boot-up they light up for
2 seconds, then turn off;
DHCP: if DHCP is enabled, they blink and stay solid periodically
Network Link LED: (Green) Solid: Indicates good network link.
Activity LED: (Red) Blinking: Indicates network activities (receiving or sending packets).
18 Receive LED (blue) while blinking, the Coordinator looks for the clearest channel to
communicate. Once it finds that channel, the light will change to solid.
19 Antenna connector
20 Power LED: (Green) Solid: Indicates Power-ON
2.6 Dimensions and Mounting - Coordinator
Position unit where required. Mark and drill the two screw holes. Once the bracket is
mounted to the wall: align back of unit over the three bracket clips, when engaged, slide
downward, the unit will snap in place.
Version A: Metal Enclosure Version B: New Plastic Enclosure
Figure 2.6 Mounting the Coordinator
Attach antenna (refer to Section 5 for Environmental/Operating Conditions) and attach
power supply.
If unit is to be mounted on a flat surface, you may take the bottom rubber feet off
the unit.
66.0 [2.60]
REF
33.0 [1.30]
93.1
[3.67]
REF
38.1
[1.50]
27.3
[1.07]
Bracket Clips (3)
Drill 2 HOLES
3.6 [ 0.14]
Use #6 Screws (Provided)
to Mount the Bracket
Ethernet
Ethernet
90.3
[3.56]
REF
32.4
[1.27]
11.7 [0.46]
38.1
[1.50]
61.6 [2.42] REF
Bracket Clips (3)
Bracket Snap
Drill 2 HOLES
3.17 [ 0.125]
Use #4 Screws (Provided)
to Mount the Bracket