Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 14)

2.1d Parts of the End Device (zED-DC-H2)
1 8 position DIP switch (under cover), sets the NID and DID of the End Device
(see Section 2.6 for details)
2 Power Switch
3 Label for Unit Address, Group No. and Network ID Address (NID)
4 Wall mounting holes
5 Label with model and serial numbers
6 Radio module firmware revision location on label
7 Case’s tray, where the PCB is mounted
8 Case’s cover
9 Transmit blue LED (under cover)
10 One Screw attaching Cover
11 External probe/sensor through cable gland (shown for -TC option only),
or quick disconnect connector
.
Refer to Figure 2.2b for connector configurations.
12 Low Power Input, through cable gland connector
13 Antenna Mount
14 Thermocouple Input removable terminal block connector
(under cover, for -TC option only)
15 LCD Display (for units with -LCD option)
16 Low Power terminal block connector (under cover)
17 Cable Clamp for Thermocouple wiring (under cover)
Figure 2.1d Parts of the End Device (zED-DC-H2)
8
Warning:
the following parts are
ESD sensitive.