Oki MICROLINE 320 TURBO - Manual (Page 72)

72 Microline 320/321 Turbo
|
Explanations of Menu Items (Continued)
Refer to “Using Your Printer, Menu Mode, Menu Settings Table” for an overview of the menu structure.
Print Suppress Effective. If your system uses the DC1 and
DC3 codes for something other than the print suppress mode,
change the setting to No.
Proportional Spacing. Change the setting to Yes to engage
proportional spacing of characters.
Receive Buffer Size. Selects the amount of memory devoted
to holding received data. Choosing 1 Line will tie up your
computer while printing, but if you abort the print job, the
printer will stop much sooner.
Reset Inhibit. Select Yes to prevent your software from
resetting your printer's settings.
SI Select Pitch, 10 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 10 cpi and the SI
command is received.
SI Select Pitch, 12 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 12 cpi and the SI
command is received.
Size. Change to Double for double width and height printing.
Skip Over Perforation. Change to Yes if you want the printer
to go to the next page when it comes within 1" (25 mm) of
the bottom of the page. Keep it set to No if your software has
its own page formatting controls.
Style. Change to italics if you want the printed characters to
be slanted.
Time Out Print. If your software spends a long time
processing between portions of data it feeds to the printer,
change the setting to Invalid to keep your printer from
dumping the received data while it is waiting for more.
Wait Time. Sets the amount of time the printer will wait for
more data before moving to the form tear-off position.
Zero Character. If you do not want the printer to use a slash
to distinguish the number zero from the capital letter O,
change the setting to Unslashed.