Oricom Pro900 - Manual (Page 4)

2
Getting Started
Installation
Cordless Phone
1. Connect the mains adaptor (supplied) to the socket on
the back of the base unit and to the wall mains supply.
2. Connect the telephone cord to the phone socket on the
back of the base unit and into the wall phone socket.
3. Insert 2 rechargeable Ni-MH AAA
1.2V 800mAh batteries (included),
observing the correct polarity, into
the battery compartment on the
handset. Slide the battery door fi rmly into place.
4. Place the handset on the charging cradle and charge the
batteries for a full 15 hours before using it for the fi rst time.
Corded Phone
1. Connect the mains adaptor (supplied) to the socket on
the back of the base unit and to the wall mains supply.
2. Connect the telephone cord to the phone socket on the
back of the base unit and into the wall phone socket.
Select your country
After the phone is fully charged you will need to select your country.
The phone will display Welcome. Press [
]. Scroll [ ] or [ ]
to select Australia or New Zealand. Press [ ] again to confi rm.
Note:
It may take some time for the cordless handset to
power up, and it may get warm during initial charge.
This is normal.
It is good practice to put the cordless handset on the
charging cradle when it is not in use to ensure that
the handset is always fully charged.
IMPORTANT:
DO YOU HAVE BROADBAND/ADSL?
If you do, you must connect an in line fi lter (not supplied) between
the telephone socket and your Pro900 base to ensure that your
broadband and Pro900 will work properly. If you do not install
the fi lter you will experience interference on the Pro900 and your
Broadband may suffer dropouts. Please refer to the user guide of
the in line fi lter for installation.