2 oki - standard model, 2 oki — standard model – Oki POS 425S User Manual
Page 36

36
OKIPOS 425S
|
No.
Item
Function
Sets
1
Auto Cutter Unit
Selects Auto Cutter Unit Installed/Not Installed
Yes
O No
2
MICR Unit
Selects MICR Unit Installed/Not Installed
Yes(CMC-7)
Yes(E-13B)
O No
3
Print Registration
Adjusts the print position if it shifts in Forward
printing and Reverse printing
0.25mm Right
0.20mm Right
0.15mm Right
0.10mm Right
0.05mm Right
0
0.05mm Left
0.10mm Left
0.15mm Left
0.20mm Left
0.25mm Left
4
Top Adjust
Adjusts Top Of Form position when
Slip/Sprocket are used.
-1.75mm ~ +1.75mm
*Can be set in the
0.35mm unit
*Default value: 0 mm
5
Cut Adjust
Adjusts Cut Position when cutting sprocket
paper.
-1.75mm ~ +1.75mm
*Can be set in the
0.35mm unit
*Default value: 0 mm
6
Auto LF
(Auto line feed)
Selects auto line feed.
(Selects auto line feed by CR Code)
Yes
O No
7
Receive Buffer
Size
Selects Receive Buffer Size
2K
O 16K
8
Print Mode
Selects font
O Utility
HSD
9
Off-line Busy
Control
Selects conditions of BUSY
O Yes (Off-line or
receive buffer-full)
O No (Receive buffer-
full)
10
Cover Open Alarm
Selects enable/disable of print stop in Cover
Open
O Yes
No
11
Width of Roll
Paper
Selects the paper width of Roll paper (Changes
the print area)
O 76.2mm
69.5mm
12
Zero Character
Selects a zero font
Slashed
O Unslashed
13
Page Length
Selects the paper length of Sprocket paper
88.9mm
139.7mm
215.9mm
O 279.4mm
304.8mm
14
Paper End Signal
Selects the paper sensor that enables Paper End
Signal.
•
RNE: Receipt/Journal Near End Sensor
•
RE: Receipt/Journal End Sensor
O Yes (RNE or RE)
Yes (RE)
No
O = default value
2.3.2 OKI — Standard Model
A25007.doc
Note 1) In this model, an auto cutter unit cannot be installed.
Note 2) I/F control information (baud rate, etc.) and customer display connection/disconnection of serial model are set by
DIP-SW on the I/F board.
Note 3) MICR Unit selection has the following two types for MICR Read test (Refer to Section 2.6): “Yes (CMC-7),” and
“Yes (E-13B).” Normally, either selection is recognized as an actual installation status of MICR Unit, and MICR
type is selected by designation of the command.
Note 4) For No. 3, 4, and 5, adjust to the proper values at factory shipment.