Roland MP-500 - Manual (Page 23)

23
Try Recording Your Performance
5.
Press the [Rec] button to turn on the indicator.
The keyboard is put in record standby mode.
The [Play] button’s indicator flashes.
fig.6-05.e
If you want to cancel the recording, then press the [Rec] button once more to make the
indicator dark.
If you wish to stop the metronome, press the Metronome [On/Off] button to make the
indicator go dark.
In the beginning it is probably a good idea to listen to the metronome as you record.
The sound of the metronome is not recorded.
6.
Recording will begin when you play a note on the keyboard.
The [Play] button indicator will change from blinking to lit.
Instead of playing the keyboard, you can also begin recording by pressing the [Play]
button to make the indicator light. In this case, you will hear a two-measure count before
recording begins.
Listen to the metronome, and play along with the tempo.
fig.6-06
7.
When you are finished recording, press the [Play] button to make
the indicator go dark.
fig.6-07.e
You can use a MIDI sequencer to save the recorded performance. Please refer to
“Transmitting Performance Data from MIDI Out” (p. 35).
Press Lit
Rec Rec
Play Play
Press Dark
MP-500.e.book 23 ページ ２００３年６月１１日 水曜日 午前９時４６分